What Should We Pay Attention To When Installing The Filter Press?

What should we pay attention to when installing the filter press?

The following aspects should be paid attention to when installing the filter press:

1. There should be enough space for operation and maintenance around the filter press. The hydraulic pressure filter press should choose an appropriate position to place the hydraulic station to ensure that the hydraulic station can work normally.

2. Place the filter plate according to the work requirements, and arrange the feeding, washing and drainage pipelines. Equipped with filter pressure display gauge and return channel to control filter pressure. In the case of diaphragm squeeze type, arrange compressed air/water pipelines.

3. Hydraulic filter press, inject clean hydraulic mechanical oil into the hydraulic station tank, and the operating temperature is >-5℃; if the ambient temperature is low, hydraulic oil with similar viscosity and low freezing point can be used.

4. The filter press should be installed on a flat concrete foundation. The thrust plate machine feet at the feed end are fixed on the foundation with anchor bolts; anchor bolts are not used at the bracket end, or two nuts are used to lock the anchor bolts after positioning, leaving an appropriate gap between the nut washers and the machine foot base. The machine feet can be slightly retracted. Before positioning, the installer should correct the verticality of the beam and the large plane of the thrust plate.

5. Mechanical or hydraulic pressing device, the starting motor should work correctly when the power is turned on. The pressure gauge should rise steadily when the hydraulic pressure is applied, and there should be no leakage in the hydraulic system. The working pressure of the hydraulic station should be adjusted correctly according to the size of the machine. If the oil tank is found to be insufficient after the test run, it must be replenished.

6. The foundation structure should be designed by construction engineers according to the equipment load. It is advisable to grout the anchor bolts twice with reserved holes.

After the filter press completes the above operations, there will be basically no problems in the installation of the filter press. As long as you pay attention to the maintenance and upkeep of the filter press in daily use, you can ensure its working condition and efficiency.